一、養護室超聲波加濕器產品簡介：
養護室超聲波加濕器是我公司新開發的產品，采用超聲波負離子加濕，養護室超聲波加濕器廣泛用于公路、橋梁、鐵路、建筑、水利標準養護室的試塊養護，養護室超聲波加濕器高效節能也可用于紡織、農業、醫療、食品加工等，是實驗室、生產車間對濕度要求較高場所的理想產品。
Product introduction of ultrasonic humidifier in curing room:
The ultrasonic humidifier in the curing room is a new product developed by our company. It adopts ultrasonic negative ion humidification. The ultrasonic humidifier in the curing room is widely used in the maintenance of test blocks in highways, bridges, railways, buildings, and water conservation standard curing rooms. It can also be used in textile, agriculture, medical treatment, food processing, etc. It is an ideal product for laboratories and production workshops with high humidity requirements.
二、養護室超聲波加濕器技術參數：
★電源電壓：220AVC 霧化水量：≥3000ml/hr
★工作電壓：48VDC 霧化顆粒直徑：1-10u
★工作電流：42-5.0A 換能片壽命：3000-5000hr
★功率：300W A佳水溫：30±5℃
★外形尺寸：400X320X400mm 適用體積：20-100m3
Technical parameters of ultrasonic humidifier in the curing room:
★ Power supply voltage: 220AVC Atomized water volume: ≥3000ml / hr
★ Working voltage: 48VDC atomizing particle diameter: 1-10u
★ Working current: 42-5.0A Transducer life: 3000-5000hr
★ Power: 300W A best water temperature: 30 ± 5 ℃
★ Dimensions: 400X320X400mm Applicable volume: 20-100m3
三、養護室超聲波加濕器操作步驟：
★ 斷開霧化器電源，取出霧化器并擦干凈霧化器；
★拆開換能片備件包裝袋，取出工具匙及備用霧化換能片；
★ 用工具匙擰開霧化器壓圈，取出壓圈及換能腔中換能片；
★清理換能腔中的污垢及雜物并用軟布擦干凈換能腔；
★把新的換能片放入換能腔(注意裝配時換能片的方向)，用工具匙擰緊壓圈。
Third, the operating steps of the ultrasonic humidifier in the conservation room:
★ Disconnect the power of the atomizer, remove the atomizer and wipe the atomizer clean;
★ Remove the packaging bag for the spare parts of the transducer sheet, take out the tool spoon and spare atomizing transducer sheet;
★ Unscrew the pressure ring of the atomizer with a tool spoon, take out the pressure ring and the transducer in the transducer cavity;
★ Clean the dirt and sundries in the transducer cavity and wipe the transducer cavity with a soft cloth;
★ Put the new transducer into the transducer cavity (note the orientation of the transducer during assembly), and tighten the pressure ring with a tool spoon.
四、養護室超聲波加濕器安裝步驟：
★選擇合適的位置放置好加濕機
★將自來水管與加濕機過濾器進水口連接好
★ 向水箱內注水(本品為自動調整水位)
★ 把加濕機電源線與風機電源線接到相應電源上
① 主機電源接48VDC
② 風機電源接24VDC
★將開關電源接到相應的控制設備上
(200VAC)即可投入工作、請參考接線圖(1)
Fourth, the installation steps of the ultrasonic humidifier in the conservation room:
★ Choose the right place to put the humidifier
★ Connect the water pipe to the water inlet of the humidifier filter
★ Fill the water tank (this product is automatic water level adjustment)
★ Connect the humidifier power cord and fan power cord to the corresponding power supply
① Host power supply is connected to 48VDC
② Fan power is connected to 24VDC
★ Connect the switching power supply to the corresponding control equipment
(200VAC) can be put into work, please refer to the wiring diagram (1)
五、養護室超聲波加濕器換能機備件及使用方法：
換能面在正常使用狀態下，換能片的使用壽命約為3000-5000小時，當出現霧化量明顯衰減情況下，請先清潔換能片表面水垢或雜質，如果清潔后霧化量仍然不足，則需要更換換能片。
V. Spare parts and use methods of ultrasonic humidifier transducer in curing room
Under normal use of the transducer surface, the service life of the transducer is about 3000-5000 hours. When the atomization amount is significantly attenuated, please clean the scale or impurities on the surface of the transducer sheet. If the atomization amount is still insufficient after cleaning, , You need to replace the transducer.
六、養護室超聲波加濕器特點：
采用集成投入式超聲波加濕機芯，具有無機械驅動，低噪聲，高效率，霧化量大等優點。工作時，水經過過濾器進入箱內，霧化器高頻振蕩產生一定濃度的負離子，通過風機將其排出，過濾器可去除水中的泥沙、鐵銹等，具有高效能、大流量、壽命長、易維護的特點，更加延長霧化器的使用壽命。箱體采用工程塑料加工而成，耐壓、耐高溫且防腐性好，同時采用雙出口，方向隨意可調使?jié)穸雀泳鶆颉１緳C(jī)所帶開關電源用220V交流，輸出48VDC供霧化器，24VDC供風機，保證了用戶的使用安全。
注：本機設有內置電子溫控保護開關(斷開溫度為65±5℃，復位溫度為40±5℃)和缺水保護開關，請放心使用。
Six, the characteristics of ultrasonic humidifier in the conservation room
The integrated input ultrasonic humidification movement has the advantages of no mechanical drive, low noise, high efficiency, and large atomization. During work, the water enters the tank through the filter, and the atomizer generates high-frequency negative ions with a certain frequency, which is discharged by the fan. The filter can remove the sediment, rust, etc. in the water, with high efficiency, large flow and long life And easy to maintain, further extend the life of the atomizer. The box is made of engineering plastics, which is pressure-resistant, high-temperature-resistant and has good corrosion resistance. At the same time, it uses double outlets and the direction can be adjusted at will to make the humidity more uniform. The switching power supply provided by this machine uses 220V AC, outputs 48VDC for the atomizer, and 24VDC for the fan, ensuring the user's safety.
Note: This machine is equipped with a built-in electronic temperature control protection switch (disconnection temperature is 65 ± 5 ℃, reset temperature is 40 ± 5 ℃) and water shortage protection switch. Please use it with confidence.
七、養護室超聲波加濕器保養及維修注意事項：
★ 使用本加濕機，請務必使用我公司提供的開關電源，開關電源在接線完成后應固定在墻上等干燥、不易被碰到的位置，且工作時不要觸摸電源任一部位，以防觸電，開關電源所放位置應通風良好，工作時外表溫度會高達40-50℃，請放心使用。
★當需群式使用加濕機時，請務必按要求分別單獨配備電源，不能用單個電源連接多個加濕機工作。
★在加濕機工作一段時間后，由于水垢會沉積在霧化器換能片表面，直接影響出霧量，建議每隔2-3周清洗一次，要用細軟棉布輕擦換能片，去除污垢(切不可用洗衣粉、洗滌靈等帶腐蝕性的清洗劑清洗)保持加濕機A佳的工作狀態。
注：根據各地水質的不同，可適當縮短或延長清洗的周期。
★霧化器經長時間工作后(約3000小時)霧化量會逐漸減小，此時請參照?qǐng)D(2)更換新霧化片。
★定期清洗過濾器濾芯，如長時間工作濾芯被垢堵塞則需更換。
★ 嚴禁將帶腐蝕性的液體注入水箱，確保加濕機的正常工作和使用壽命。
Seven, maintenance and repair precautions of ultrasonic humidifier in the conservation room
★ When using this humidifier, please be sure to use the switching power supply provided by our company. After the wiring is completed, the switching power supply should be fixed to a dry, hard-to-touch location such as a wall, and do not touch any part of the power supply during work to prevent electric shock The place where the switching power supply is placed should be well ventilated, and the surface temperature will be as high as 40-50 ° C during work. Please rest assured.
★ When you need to use the humidifier in groups, please be sure to provide power separately according to the requirements. Do not use a single power supply to connect multiple humidifiers to work.
★ After the humidifier works for a period of time, because scale will be deposited on the surface of the atomizer transducer sheet, which directly affects the amount of fog, it is recommended to clean it every 2-3 weeks, and wipe the transducer sheet with a soft cotton cloth to remove dirt (Do not use corrosive detergents such as washing powder and detergent) to keep the humidifier A in good working condition.
Note: The cleaning cycle can be shortened or prolonged appropriately according to the water quality in different places.
★ After long time work (about 3000 hours), the atomization amount of the atomizer will gradually decrease. At this time, please refer to Figure (2) to replace the atomizer with a new one.
★ Clean the filter element regularly. If it is blocked by dirt for a long time, it needs to be replaced.
★ It is strictly forbidden to inject corrosive liquid into the water tank to ensure the normal operation and service life of the humidifier.
