產品型號：JSY0101
產品名稱：液化石油氣蒸氣壓測定器JSY0101
產品說明：
JSY0101液化石油氣蒸氣壓測定器（LPG法）
一、符合GB/T6602、ISO4256、ASTMD1267標準
二、主要技術參數：
控溫方式：進口數顯溫控儀自動控溫
控制溫度：37.8±0.1℃
測壓范圍：0～2Mpa
壓力顯示：數字壓力顯示
彈體容積：上室 Φ51×254±3(mm)
容積，33 .33％
V上 : V下1＝1.97～2.03
容積，20％
V上 : V下2＝3.95～4.05
振蕩方式：水平自動正反向旋
振蕩速度：旋轉320度／20±1秒
工作電源：AC220V±10％ 50HZ
功 率：2.5kw
三、性能及特點
1、采用技術，試驗彈自動水平往復旋轉振蕩， 20秒鐘旋轉320°再反方向20秒鐘旋轉320°，振蕩強度絕不低于人工振蕩，大大減輕了勞動強度。
2、采用進口數顯溫控儀自動控溫，控溫精度高，操作簡便，壽命長。
3、采用壓力傳感器測量壓力，用數顯表直接顯示壓力值，無須換算。
4、試驗彈及接頭均經過高壓試驗，符合標準要求，保證儀器安全可靠。
5、水浴槽與試驗彈均采用不銹鋼材料制成，防銹性能好。采用進口快速接頭連接儀器與試驗彈，操作輕松方便。
6、儀器配有兩個上室，兩個33 .33％下室和兩個20％下室，可在儀器上進行試樣的平行試驗。
JSY0101 LIQUEFIED petroleum gas Vapor pressure tester (LPG method)
I. Comply with GB/T6602, ISO4256, ASTMD1267 standard
Ii. Main Technical parameters:
Temperature control mode: Automatic temperature control with imported digital display temperature controller
Control temperature: 37.8±0.1℃
Pressure measuring range: 0 ~ 2Mpa
Pressure display: digital pressure display
On the projectile volume: room Φ 51 * 254 + 3 (mm)
Volume, 33.33 %
V up: V down 1 = 1.97 ~ 2.03
Volume, 20%
V up: V down 2 = 3.95 ~ 4.05
Oscillation mode: horizontal automatic positive and negative rotation
Oscillation speed: rotation of 320 degrees / 20±1 second
Power supply: AC220V± 10% 50HZ
Power: 2.5 kw
Iii. Performance and Characteristics
1. Adopting foreign advanced technology, the test projectile will automatically reciprocate and rotate horizontally, rotating 320° for 20 seconds and then rotate 320° in the opposite direction for 20 seconds. The oscillation intensity is no less than the artificial oscillation, which greatly reduces the labor intensity.
2. Adopt imported digital display temperature controller to automatically control temperature with high precision, easy operation and long service life.
3. Use pressure sensor to measure pressure, and use digital display table to directly display pressure value without conversion.
4. The test projectile and joint have been tested under high pressure and meet the standard requirements to ensure the safety and reliability of the instrument.
5. Water bath and test bomb are made of stainless steel, with good rust resistance. Adopt imported quick joint to connect instrument and test bomb, easy and convenient to operate.
6. The instrument is equipped with two upper Chambers, two 33. 33% lower Chambers and two 20% lower Chambers for parallel test of samples on the instrument.
