當前位置：鎮江海太鍋爐公司>>導熱油鍋爐>>導熱油鍋爐

導熱油鍋爐

返回列表頁

參考價

面議

具體成交價以合同協議為準

產品型號

品牌

廠商性質其他

所在地

在線詢價 收藏產品查看聯系電話

聯系方式：查看聯系方式

更新時間：2022-11-17 16:19:39瀏覽次數：313次

聯系我時，請告知來自環保在線

產品分類 品牌分類

  導熱油鍋爐

全部產品列表

暫無信息

鎮江海太鍋爐公司

經營模式：其他

商鋪產品：4條

所在地區：

詢價 給他留言

產品簡介

導熱油鍋爐

詳細介紹

產品特點:

■ 導熱油鍋爐是基于強制循環的設計思維而開發的直流式特種鍋爐。

■ 封閉循環供熱，與大氣相通，可延長鍋爐的使用壽命，液相輸送熱能，熱損失小，節能，環保效果好。

■ 本體采用煙氣三回程盤管設計，這種直流式結構，決定了傳統鍋爐所不具有的安全性。

■ 由于采用盤管式結構，因此，受熱面充足，使其具有較高的熱效率。

■ 導熱油鍋爐，顯著的特點是逆流換熱，燃燒排煙溫度與熱導油出口溫差在 30 ℃以下。

■ 導熱油鍋爐其的結構，主要是在較低的壓力下運行，獲取 450 ℃ 以下的工作溫度，具有低壓高溫的特點。

Boiler explanation

※ Heating conducting oil boiler is a direct special boiler based on circulation compulsion design ideas.

※ Closed circulation heating connected to the atmosphere can prolong the life of the boiler. Liquid phase transportation of heat minimizes the loss the heat. The result of energy save is significant and the protection of the environment is great.

※ The body uses three-loop piping design. This is a direct circulation structure. The design decides the safety not possessed by traditional boiler.

※ Due to the piping design, the heating surface is abundant with high efficiency in heating.

※ A obvious characteristic of heat conducting oil boiler is reverse heat circulation. The difference of temperatures between combustion exhaustion and heat conducting oil is below 30℃.

※ The excellence of the structure of the heat conducting oil boiler is to operate under low pressure to obtain working temperature below 450 ℃. These are its characteristics of low-pressure and high-temperature.

Excellent System, Outstanding Characteristics

Perfect Design, Safe and Reliable

High Thermal Efficiency, Resources Saving

Easy Maintenance, Long Life

使用注意事項：

Special item to pay attention to when using:

■ 使用斯大導熱油作為熱載體的油、氣的熱載體鍋爐，系統應配備膨脹槽，儲油罐、安全組件，測量儀表和控制裝置。

■ 導熱油投入使用時，在開始運行階段，先啟動循環油泵，運行半小時后，再點火升溫，初次使用時應緩慢升溫，每小時升溫約 20 ℃，當升溫至180~ 200℃時，再保溫一段時間，方可投入正常使用。

■ 在使用中應認真檢查，嚴防水、酸、堿及低沸點物漏入使用系統，系統應裝過濾裝置，防止各種雜物進入，保證油品純度。

■ 經使用半年后，應進行一次油品分析，長期使用后，若發現傳熱效果差，或其它異常情況，應對油品進行分析，根據分析結果決定添加或更換，判斷標準量：堿碳不大于1.5%，酸值不大于0.5mgK(OH)/g,燃點變化不小于20%，粘度變化不大于15%，其中一項超標應更換新油。

■ 為確保導熱油的正常使用壽命和導熱效果，嚴禁超溫使用。

※The oil and gas heat conducting boilers that use Star heat conducting oil to be the heat conduction should be equipped with expansion groove, oil storage tank, safety parts, measurement instruments and controlling equipments.

※When using heat conducting oil, at the beginning stage of operation, first start the circulation oil pump. After half an hour of operation, inflame and raise the temperature. When first using the boiler should raise the temperature slowly, 20℃ increase per hour. When the temperature reaches 180~ 200℃, keep the temperature for awhile before normal operation.

※Diligently perform inspections during the operation. Prevent water, acid, and base and other low-heating-point substance to enter the operating system. There should be filter system installed to prevent impurities from entering, to guarantee the purity of the oil.

※ After using for half a year, an oil sample analysis should be performed. After long-term use, if poor heating conduction is detected or other unusual conditions occur, analysis of the oil sample should be performed. There should be addition or exchange based analysis results: alkali carbon no greater than 1.5% and acidic value no greater than 0.5mgkoH/g. Point-to-point change is no less than 20% and adhesive degree is no greater than 15%.

※Any of these degrees is out of the standards should have new oil changed.

配套輔機參數：

Special item to pay attention to when using:

*的工藝流程：

Advanced work process

有機熱載體鍋爐是一種新型的特種加熱鍋爐，具有低壓高溫的工作特點，工作壓力在0.1Mpa，甚至常壓供熱溫度，液相340攝氏度或汽相400攝氏度，整體結構具有一定的彈性，考慮到運行中受熱后各部件的自由膨脹，采用彎曲盤管式受熱面，為了運行的更為安全、高效，還增加了空氣預熱器，爐膛內燃燒度加強，流速也增加，使得更為高效、環保、節能的服務于各個行業。

Organic heat conducting boiler is a new special heating boiler with low-pressure high-temperature specialty. The work pressu, re is at 0.1Mpa, even for the normal pressure heating temperature. At liquid phase of 340 degrees Celsius or liquid phase 400 Celsius, the whole structure is elastic. With the consideration of the free expansion after heating of various parts in operation, winding piping heating surface is used for safer, more efficient operation. In addition, air pre-heater is used and increased combustion temperature in the hearth, and increased flowing speed. It makes the operation more efficient, environmental friendly and energy saving for all industries.

鍋爐房示意圖：

Boiler抯 room diagram

型號		單位	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L	YY(Q)L
			350	460	580	700	930	1200	1400	1750	2100	2350	2950	3500	4100	4650
			Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)	Y(Q)
額定熱輸出功率		KW	350	460	580	700	930	1200	1400	1750	2100	2350	2950	3500	4100	4650
熱效率		%	83
熱效率		%	83
總發熱量		10⁴Kcal/h	30	40	50	60	80	100	120	150	180	200	250	300	350	400
出口管徑		DN(mm)	65	65	80	80	100	100	125	125	150	150	150	200	200	200
煙囪直徑		mm	250	300	350	400	450	500	550	660	650	700	750	800	850	900
煙囪高度			12	12	12	12	12	12	12	12	12	12	15	15	15	15
外形尺寸		直徑mm	1480	1500	1550	1550	1570	1740	1760	1850	1900	1930	2000	2090	2210	2290
		長mm	1480	1500	1550	1550	1570	1740	1760	1850	1900	1930	2000	2090	2210	2290
		寬mm	1170	1180	1220	1260	1350	1670	1750	1880	1950	2060	2180	2380	2610	2770
燃料耗量	輕油	Kg/h	35	46	58	70	95	121	131	176	212	236	297	352	412	468
	天然氣	NM³/h	42	56	70	85	114	147	159	213	257	286	360	427	500	567
	城市煤氣	NM³/h	90	119	149	181	242	312	338	453	546	608	765	907	1062	1205
油泵	流量	M³/h	20	28	34	40	43	60	75	100	110	120	160	200	240	280
	揚程	M	40	45	45	50	50	50	50	53	54	55	60	60	60	65
	耗電	KW	5	7.5	7.5	10	15	15	20	25	30	40	50	60	75	100
運輸總量		KG	3300	3400	3700	4000	5500	6300	8500	10600	12000	12800	16800	20000	24800	29100